EMBALMING MACHINES

MARK IV B232/004	MARK V B232/05

0 to 60 lbs. Pressure at your Discretion Flow Rate: 0 to 1 gpm	High Pressure: 0 to 80 lbs. Flow Rate: 0 to 1gpm Heavy Duty Constant Pressure and/or Pulsating Feature an the Flip of a Switch
Porty-boy has proven itself to be the most versatile machine a skilled professional embalmer can use. It allows you to match your know-how results on each individual case. Tens of thousands are in service throughout the world. Some have been on the job for over three decades with only minor repairs in all this time! Features: 1/6 hp motor - quieter, smoother running Pump has one moving part Automatic shut off when fluid runs out No creep controls Nylon dipped cabinet Quick Disconnect Hose standard In line stop cock pilot light shows when machine is operating	MARK V - the ultimate modern embalming machine! Porty-boy continues to keep pace with modern technology with superior components and materials. Pressures over 80 lbs. are no longer needed with today's improved chemicals. Mark V lowest pressure setting of 1-1/2 lbs. permits injection at minimum pressure and small flow rate. Features: 1/6 hp motor - quieter, smoother running Pump has one moving part Automatic shut off when fluid runs out SST Pulsator No creep controls Nylon dipped cabinet Quick Disconnect Hose standard In line stop cock pilot light shows when machine is operating

DUOTRONIC INJECTORS

The DUOTRONIC INJECTOR features an epoxy coated steel case with a 3 gallon glass tank.

MODEL	DUOTRONIC 1 B232/09	DUOTRONIC III B232/03	DUOTRONIC IV B232/04
CABINET	18 gauge stainless steel	18 gauge stainless steel	18 gauge stainless steel
TANK	3 gallons	3 gallons	3 gallons
MOTOR	2 speed 1/2 HP Quick disconnect. Bronze centrifugal pump. Gauge 0 to 30 pounds pressure Weight 53 lbs.	1 speed 1/8 HP Quick disconnect. Magnetic drive centrifugal pump. no shaft seals, saves wear & tear. Gauge 0 to 30 pounds pressure Weight 37 lbs.	2 speed 1/2 HP Quick disconnect. Direct drive pump. Gauge 0 to 100pounds pressure. Automatic shut-off.

WATER CONTROL UNIT

B232/0100 (NOT INCLUDED WITH EMBALMING MACHINES)
B232/0200 (TUBING KIT FOR WATER CONTROL UNIT)

The water control unit isolates the embalming room water supply from the funeral home. All supply lines coming in contact with the morgue table has a backflow prevention or 3" air gap. The aspirating of waste is visible to operation - no splash or odor. Aspirates through air gap directly into drain.

The unit installs for precisely trouble free service, and our new improved model includes even more features to make your professional work easier and cleaner.

FILLER - gooseneck filler spout now provides both hot and cold water to embalming machine - and it's easily controlled by single lever mix value.

OPEN END ASPIRATOR - moved close to the front so waste is easily seen.

QUICK COUPLERS - new coupling method for water and aspirating hoses allow snap on/of connections so hoses can now be stored out of sight, ready for use.

DROP - IN - just drop the pre-plumbed unit into a cut- out on your counter top! The unit has a stainless steel plate of a 15 gauge material allowing for installation on a counter as shallow as 18 inches. The stainless steel plate is now fastened with a new method for easy installation. Just have your plumber supply 1" cold water, 1/2" hot water and 1-3/4" waste lines.

West:

South:

East:

EMBALMING MACHINES